CQI-30 : Special Process : Rubber Processing System Assessment - Mixing & Molding, 1st Edition (Hardcopy with Downloadable Assessment)

The goal of the Rubber Processing System Assessment is the development of a rubber mixing and molding management system that provides for continual improvement, emphasizing defect prevention and the reduction of variation and waste in the supply chain.

The Rubber Processing System Assessment, coupled with an internationally recognized quality management system and applicable customer-specific requirements, defines the fundamental requirements for a rubber mixing and molding management system.

The Rubber Processing System Assessment is intended to provide a common approach to a rubber mixing and molding management system for automotive production and service part organizations.

Table of Contents
About AIAG
Foreword
Acknowledgements
Table of Contents
Introduction

General
Process Approach
Rubber Processing System Assessments Goals
Assessment Process
Assessor Qualifications
Other Requirements

1 Scope
1.1. General
1.2. Application

2 The Rubber Processing System Assessment Procedure
The CQI-30 Audit Process Overview
Instructions for Completing Section 1: General, Pre-Audit Survey
Instructions for Completing Section 2: Management Responsibility & Quality Planning
Instructions for Completing Section 3: Job Audit
Instructions for Completing Section 4-8
Section 4 - Rubber Mixxing
Section 5 - Inspection and Testing
Section 6 - Facilities and Equipment
Section 7 - Molding
Section 8 - Substrate Preparation

Glossary